1、Chapter 5 作業題，請同學們注意題目描述。1. (R1)What are some of the possible services that a link-layer protocol can offer to the network layer? Which of these link-layer services have corresponding services in IP? In TCP?答：可能提供的服務：鏈路接入，成幀，可靠傳輸，流量控制，差錯檢測，差錯糾正，半雙工和全雙工； In IP：成幀，差錯檢測； In TCP: 成幀，可靠傳輸，差錯檢測，半雙工和全雙工。2.

2、 (R2)If all the links in the Internet were to provide reliable delivery service, would the TCP reliable delivery service be redundant? Why or why not?答：不會多余，因?yàn)門CP保證的是傳輸層的數據傳送，而link提供穩定可靠傳輸保證鏈路層的傳輸穩定，二者不完全重疊，所以TCP可靠傳輸也不會多余。例如，鏈路層協議不能保證端到端的順序，就需要TCP協議進行排序；路由器緩存溢出丟包，鏈路層協議無法解決這個問題，但是TCP可以。3. (R8)How big

3、 is the MAC address space? The IPv4 address space? The IPv6 address space?答：248 個MAC addresses; 232 個IPv4 addresses; 2128 個IPv6 addresses4. (R9)Why is an ARP query sent within a broadcast frame? Why is an ARP response sent within a frame with a specific destination MAC address?答：因?yàn)樾录尤刖W(wǎng)絡的主機是不知道路由器的IP

4、的，自己也沒有IP，所以只能廣播才能得到IP，特定的主機就會特定響應。因?yàn)槊總€主機的MAC地址都是唯一的，而ARP建立轉發表的時候會帶上MAC地址。5. (P5)Consider the 4-bit generator, G, shown in Figure 5.8, and suppose that D has the value 11111010. What is the value of R? G=1001答：D2RG的余數， R=1106. (P11)Consider a broadcast channel with N nodes and a transmission rate of

5、 R bps. Suppose the broadcast channel uses polling (with an additional polling node) for multiple access. Suppose the amount of time from when a node completes transmission until the subsequent node is permitted to transmit (that is, the polling delay) is dpoll. Suppose that within a polling round,

6、a given node is allowed to transmit at most Q bits. What is the maximum throughput of the broadcast channel? 答：情況1：QRQR+Ndpoll情況2：NQRN(QR+dpoll)兩種極端情況進行比較，明顯情況2為最大值；情況1為最小值。7. (P12)Consider three LANs interconnected by two routers, as shown in Figure 5.38.a. Redraw the diagram to include adapters.Fi

7、gure 5.38 Three subnets, interconnected by routersb. Assign IP addresses to all of the interfaces. For Subnet I use addresses of the form 111.111.111.xxx; for Subnet 2 uses addresses of the form 122.222.222.xxx; and for Subnet 3 use addresses of the form 133.333.333.xxx. （注：本題目略有修改，見紅色標注）c. Assign M

8、AC addresses to all of the adapters.d. Consider sending an IP datagram from Host A to Host F. Suppose all of the ARP tables are up to date. Enumerate all the steps, as done for the single-router example in Section 5.4.2.e. Repeat (d), now assuming that the ARP table in the sending host is empty(and

9、the other tables are up to date).答：a.b.c.d. 1. 由A的轉發表決定了數據報應該被轉發到路由器端口111.111.111.002.2. 由A的適配器生成一個攜帶以太網目的地址22-22-22-22-22-22的以太網分組.3. 第一個路由器即收到該分組并且解析了數據報。該路由器中的轉發表提示該數據報應該被轉發到122.222.222.003.4. 第一個路由器發送帶有目的地址為55-55-55-55-55-55并且源地址為33-33-33-33-33-33的以太網分組，經過IP地址為122.222.222.002的端口。5. 過程以此類推，直到分組到達

10、主機F .e. 主機A的ARP模塊一定知道本網段網關的IP地址為 111.111.111.002。主機A發送一個ARP請求(包含在一個以太網廣播幀中)。第一個路由器接收到這個請求分組并且發送給主機A一個ARP響應分組。這個ARP響應分組裝載于一個包含以太網目的地址00-00-00-00-00-00的以太網幀上。得知了路由器端口的MAC地址后，以他作為目的地址成幀，以后的步驟與上一問相同。8. (P15)Suppose nodes A and B are on the same 10 Mbps Ethernet bus, and the propagation delay between the

11、 two nodes is 225 bit times. Suppose A and B send frames at the same time, the frames collide, and then A and B choose different values of K in the CSMA/CD algorithm. Assuming no other nodes are active, can the retransmissions from A and B collide? For our purposes, it suffices to work out the follo

12、wing example. Suppose A and B begin transmission at t = 0 bit times. They both detect collisions at t = 225 bit times. They finish transmitting a jam signal at t = 225 + 48 = 273 bit times. Suppose and , At what time does B schedule its retransmission? At what time does A begin transmission? (Note:

13、The nodes must wait for an idle channel after returning to Step 2-see protocol.) At what time does As signal reach B? Does B refrain from transmitting at its scheduled time?答：9. (P16)Suppose nodes A and B are on the same 10 Mbps Ethernet bus, and the propagation delay between the two nodes is 225 bi

14、t times. Suppose node A begins transmitting a frame and, before it finishes, node B begins transmitting a frame. Can A finish transmitting before it detects that B has transmitted? Why or why not? If the answer is yes, then A incorrectly believes that its frame was successfully transmitted without a

15、 collision. Hint: Suppose at time t = 0 bit times, A begins transmitting a frame. In the worst case, A transmits a minimum-sized frame of 512 + 64 bit times. So A would finish transmitting the frame at t = 512 + 64 bit times. Thus, the answer is no, if Bs signal reaches A before bit time t = 512 + 6

16、4 bits. In the worst case, when does Bs signal reach A?答：假設在 t = 0 時刻 A開始傳輸?？紤]到以太網的最短幀長為576bit，最早在 t = 576 時刻, A 可以完成傳輸。在最壞的情況下，B 在 t = 224 時刻開始傳輸, 此時它還不知道A正在傳輸。在t = 224 + 225 = 449 時刻，B 的第一個比特到達A，因?yàn)?49576，A將在完成分組傳輸之前中斷。因此A不能在他察覺到B的傳輸之前完成傳輸。10. (P19)Suppose two nodes, A and B, are attached to opposi

17、te ends of a 900 m cable, and that they each have one frame of 1,000 bits (including all headers and preambles) to send to each other. Both nodes attempt to transmit at time t = 0. Suppose there are four repeaters between A and B, each inserting a 20-bit delay. Assume the transmission rate is 10Mbps

18、, and CSMA/CD with backoff intervals of multiples of 512 bits is used. After the first collision, A draws K = 0 and B draws K = 1 in the exponential backoff protocol. Ignore the jam signal and the 96-bit time delay.a. What is the one-way propagation delay (including repeater delays) between A and B

19、in seconds? Assume that the signal propagation speed is m/sec.b. At what time (in seconds) is As packet completely delivered at B?c. Now suppose that only A has a packet to send and that the repeaters are replaced with switches. Suppose that each switch has a 20-bit processing delay in addition to a store-and-forwar