1、CS11_Fully measured ReportProject Name Part Number CAD NumberProduct Name:CS11:_006: GEAN-PROD-GUSSET COWL RR RH立衡科技r:VCC Material standards : VDA 239-CR240LA Actual Material : CR240LAThickness: 1.3mmCoating thickness : GI50/50-U Detection time :2017/01/16CHECK RESULT 檢查結(jié)果CHECK DATE檢測日期OK.RATIOPart

2、codeP1TOTAL全尺寸OK Ratio100%OK Pos63Total Pos63SURF.型面OK Ratio100%OK Pos47Total Pos47TRIM修邊OK Ratio100%OK Pos15Total Pos15HOLE孔位孔徑OK Ratio100%OK Pos1Total Pos1RPS InformationStep 1 : Surface CheckingStep 2 : Trim CheckingStep 3 : HolesitionStep 4 : Hole size Checkingnominalactualdeviationnominalactual

3、deviationRPS1Step 5 : ThinningREPORT CHECKING THINNESMeasure thickness request: 1.3 mmactual thicknessmmLIMITS MAX : 20%11.254%21.226%31.235%41.263%51.263%678910111213141516THINNING MAXStep 6 : Appearance CheckingAppearance Checking 外觀檢查NO判定標準Control standard檢驗方法Methond判定OK、NG、N/APicture1零件是否正確？Is t

4、he rignt part?Visual目視ok2變薄率是否 料厚的 20%范 內(nèi)？THINNING MAX no more 20%Venire caliper 游標卡尺ok3是否有開裂、暗裂？No crack,deformationVisual目視ok4毛邊、毛刺、尖角是否 0.3mm 范圍內(nèi)？glitches, indenion,damaged,Venire caliper 游標卡尺ok5是否有模痕、壓傷（無手感可接受）？No roughness detect with the handwith the handok6是否有拉傷、劃傷？No degradation or deformati

5、on手觸 with the handok7是否有起皺、變形（裝配面平面度需0.2MM 以內(nèi)）？No crack,deformationVisual /Venire caliper目視/游標卡尺ok8是否有生銹？Rust?Visual目視ok9字印是否正確、明顯且無手 感？Marking information crrect ?Visual/ with the hand目視/手觸ok10公差是否與 3D 公差相符？Report tolerance is the same with 3D?檢查 checkingok11零件定位是否與檢具定義相符？PRS is the same with gauge?檢具 gaugeok12料邊斷差是否超過公差帶的 50%？ Trim no moren 50% out of tolerance?目視/檢