1、淬火爐安全操作規程Safe operation rules for quenching furnace一、開機前的準備Preparations before starting up1.關閉各控制柜門并檢查門碰開關可靠有效；Close all control cabinet and check whether door touch switch is reliable and effective;2.檢查控制面板指示燈完好；檢查各接地線可靠連接。Check whether indicator light of control panel is in good condition; Check w

2、hether grounding wire is reliably connected. 二、開機作業Starting up operation將熱電偶引線“+ -”接于儀表后部接線端。Connect the lead of thermocouple“+ -”with terminal located in the rear part of gauge.將電進線和輸出線按接線圖所示，接于控制器接線板上。Connect input line and output line with the wiring board of controller according to wiring diagra

3、m.調節調零器使指針位于“0”位。Adjust zero adjuster to make pointer stay“0”position.打開電源開關，將溫設定調至所需溫度。Turn on the power switch, and adjust the temperature to the desired temperature.打開溫度控制器電源開關，綠燈亮，接觸器吸合，電流表指示相應電流值，電熱絲通電升溫，指針向右偏轉，達到溫度值后，溫度控制器自動切斷電源，接觸器斷電，同時切斷電熱爐電源，綠燈滅、紅燈亮，當爐溫低于所需溫度時，控制器自動接通電源，紅燈滅，綠燈亮，進行升溫，如此反復，自動

4、調節爐內溫度。Turn on the control switch of temperature. When the light turns green, contactor absorbs, and ampere meter indicates corresponding current value. Heater strip heats up and indicator turns to the right. Temperature controller cuts power off automatically after reaching certain temperature, and

5、 contactor suffers power failure. The power of electrothermal furnace is off at the same time. Green light goes off, and red light goes on. When the furnace temperature is blow desired temperature, red light goes off, green light goes on. Furnace temperature is adjusted automatically.使用電爐，切記超過最高溫度。It is forbidden to exceed maximum temperature when workers use electric furnace.三、保養maintenance 不經允許，不可移動設備。It is forbidden to move equipment without permission. 要保持場地干凈。Keep the site neat and tidy. 作好設備及工作場地的整理、整頓、清掃、清潔。Keep 5S standard in the work site an